Classic Australian Wooden Power Boat Association

A member is looking for someone with some expertise on Dodge Kew (6 cylinder side valve) motors. He has a motor that is believed to be complete and in good order, but needs some reassembly.

Can anybody recommend someone or a company in Melbourne?

Greg

Fairly sure that I have a manual for that type of engine here somewhere as I have a vintage truck from 1929 that has that type of engine in it. They were fairly similar from late 20's until mid/late 40's the only thing that really changed was that they went from poured white metal bearings for the big ends to shells.
If I remember when I rebuilt mine it was not any harder than a holden red motor to assemble just a bit bigger and much heavier.

I will have a look
cheers
peter

Greg,
you can pass on my number if you want, I have a few recommendations that may help.
Alan

I have most of a manual here, well all the important stuff for rebuild and on last count about 5 engines.

Jeff

Thanks gents, but I think he is looking more along the lines of someone to do the work.
Greg

May well be worth a call to Dandenong Rebores Pty Ltd (at Hammond Road Dandenong) They seem to rebuild just about everything