Classic Australian Wooden Power Boat Association

G'Day all. For any one interested I will have a go at posting some photos of our Chris Craft, It looked OK in the original photos but not up close which started right or wrong a tidy up.
I started with sanding the bottom back to bare timber and some of the suspect joints sealed with 3M -5200 followed by 2 coats of Norglass epoxy wood sealer, 2 more coats of Norglass epoxy Shipshape Primer/undercoat and 2 coats of Norglass Premium Gloss enamel teal colour then mixed with a small amount of Norglass green to give it a more of a turquoise shade, all with much sanding between coats followed by the original white band around the water line also in Norglass Premium gloss enamel.
The deck has been striped of all hardware to be chromed and the windscreen removed to refinish the deck and add new striping lines, that's the next job.now for the photos. Brian.


No good on the photos it states file to big only tried for one photo. How do I make the photo file smaller?

Here we go again hope more more luck.
Something I'm doing is not right.

ONE MORE TIME

2nd time lucky

Finished bottom

Looking very good indeed Brian

the loud end

can't wait to see it in the flesh. Is it coming up to Narrandera behind a tank?

Well spotted Al

Hi. Alan. Yes I hope to be at Narrandera all going well.looking forward to it.And yes well spotted you can't tell from only the front but it's a 59 Retractable,fold away steel roof model U.S. import. Brian.